Joe Clarke Tue, 10/20/2009 - 12:19

UT doesn't care about the end host type. So long as the MAC address shows up in the switch CAM/MAC table, UT will learn it.

nawas Tue, 10/20/2009 - 12:24

But it doesn't seem to work in my case. I have this several Cisco 4510 that are fully managed in RME, I get the end host from every port but not from the ports that are connected to ESX servers, I do show mac on that port I see tons of mac address for the hosts behind esx but none appears in UT.

Joe Clarke Tue, 10/20/2009 - 14:16

Then you have to allow UT to acquire the end hosts on those ports under Campus Manager > Administration > User Tracking > Acquisition > Configure Trunk for End Host Discovery.

Actions

This Discussion