H-REAP and Vlan mappings

Unanswered Question

Hi folks


I have a 1131-AG accesspoint and a 4402 WLC running 6.0.182 software.


I've configured the access-point as a H-REAP AP, and configured 2 local switched Wlan's and 1 central switched Wlan on the access-point.

This worked fine - until I booted my access-point - it did never reach the WLC again (or - it did, but lost the connection).


I did some troubleshooting, and found out:

-With the Native Vlan set to 400 - the access-point switches from Fa0 to Fa0.400 with the enc dot 400 native set.

-When adding one SSID - it still works after reboot etc.

-When adding the second SSID - it fails!

The problem is that the configuration now says: enc dot 400 (with NO native argument).

This means that the AP looses connection to the network after initial config is done by the WLC...



Anyone seen this before, and does it have a fix?


Best Regards

[email protected]

CCIE 14647

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode