EIGRP not working

Unanswered Question
Oct 21st, 2009

I have the follow Cisco switch:

WIENEU_CORE#sho ver

Cisco IOS Software, C3550 Software (C3550-IPBASE-M), Version 12.2(25)SEB4, RELEASE SOFTWARE (fc1)

Copyright (c) 1986-2005 by Cisco Systems, Inc.

Compiled Tue 30-Aug-05 13:14 by yenanh

ROM: Bootstrap program is C3550 boot loader

WIENEU_CORE uptime is 3 years, 5 weeks, 5 days, 1 hour, 34 minutes

System returned to ROM by power-on

System restarted at 16:10:29 GMT Tue Sep 12 2006

System image file is "flash:c3550-ipbase-mz.122-25.SEB4/c3550-ipbase-mz.122-25.SEB4.bin"

Cisco WS-C3550-48 (PowerPC) processor (revision S0) with 65526K/8192K bytes of memory.

Processor board ID CAT1012Z3P5

Last reset from warm-reset

Running Layer2/3 Switching Image

Ethernet-controller 1 has 12 Fast Ethernet/IEEE 802.3 interfaces

Ethernet-controller 2 has 12 Fast Ethernet/IEEE 802.3 interfaces

Ethernet-controller 3 has 12 Fast Ethernet/IEEE 802.3 interfaces

Ethernet-controller 4 has 12 Fast Ethernet/IEEE 802.3 interfaces

Ethernet-controller 5 has 1 Gigabit Ethernet/IEEE 802.3 interface

Ethernet-controller 6 has 1 Gigabit Ethernet/IEEE 802.3 interface

48 FastEthernet interfaces

2 Gigabit Ethernet interfaces

The password-recovery mechanism is enabled.

384K bytes of flash-simulated NVRAM.

Base ethernet MAC Address: 00:17:94:23:1E:00

Motherboard assembly number: 73-5701-10

Power supply part number: 34-0967-03

Motherboard serial number: CAT10120FQQ

Power supply serial number: DTH1005895S

Model revision number: S0

Motherboard revision number: A0

Model number: WS-C3550-48-SMI

System serial number: CAT1012Z3P5

Configuration register is 0x10F

I have configured routing on, but when I try to configure eigrp i get the message 'Protocol not in this image'.

Can I upgrade or does the protocol not work on this device?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Loading.
Jon Marshall Wed, 10/21/2009 - 08:19

Raj

EIGRP is not supported in the SMI (Base) image. You need to upgrade the image to the EMI version. This can be done on the same switch but there will be a cost to upgrading.

Jon

RVirdi Thu, 10/22/2009 - 00:09

Thanks Jon.

That's exactly the answer I was hoping for.

Actions

This Discussion