LMS 1900

Unanswered Question
Oct 21st, 2009


I have 1900 devices not getting discovered. Only one got discovered after I added it as a seed device but it does not show the cdp neighbours in topology map.

They have CAT OS and is there any issue with catOS devices :

na100110#sh ver

Cisco Catalyst 1900/2820 Enterprise Edition Software

Version V9.00.03

Copyright (c) Cisco Systems, Inc. 1993-1999

na100110 uptime is 101day(s) 07hour(s) 18minute(s) 32second(s)

cisco Catalyst 1900 (486sxl) processor with 2048K/1024K bytes of memory

Hardware board revision is 5

Upgrade Status: No upgrade currently in progress.

Config File Status: No configuration upload/download is in progress

15 Fixed Ethernet/IEEE 802.3 interface(s)

Base Ethernet Address: 00-02-B9-4E-20-00

I have snmp configured as well.

Please advise.(LMS 3.1)


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Joe Clarke Wed, 10/21/2009 - 09:33

It's been a while since I used a 1900 switch. You should be able to get to a CLI, then run "show cdp nei" to see its CDP neighbors. Are they showing up there?


This Discussion