10-21-2009 12:21 PM - edited 03-06-2019 08:14 AM
HI,
Can anyone help on this. Actually i am connecting cisco 3560 and 2960 through SFP. When i connect the port it is goes to error disabled state.And i am getting this error
%GBIC_SECURITY_CRYPT-4-VN_DATA_CRC_ERROR: GBIC in port Gi0/22 has bad crc
PM-4-ERR_DISABLE: gbic-invalid error detected on Gi0/22, putting Gi0/22 in err-disable state
ios verion of 2960
flash:c2960-lanbasek9-mz.122-44.SE6/c2960-lanbasek9-mz.122-44.SE6.bin"
ios version of 3560
flash:c3560-ipbase-mz.122-25.SEE2/c3560-ipbase-mz.122-25.SEE2.bin"
What i have to resolve this issue .
Thanks in advance
Gopinath.L
10-21-2009 12:28 PM
Hi.
Are you using Cisco-supplied SFP or is it third-party SFP? If it is the latter, that's most probably the cause.
There is a command (a hidden one) which enables the switch to accept third-party SFP. It is "service unsupported-transceiver". Be aware, though, that if you use that command, Cisco reserves the right to not provide you service in case of problems if they deem the third-party SFP to be the cause of problem.
You might have to upgrade to newer versions than the ones you have (especially on the 3560) to have the support for the command.
HTH
10-21-2009 12:34 PM
Hi,
Thanks for your help on this
Regards
Gopinath.L
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: