Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
370
Views
0
Helpful
1
Replies

7921 problem after upgrade to 1-3-3

derveniss
Level 1
Level 1

‎10-22-2009 06:32 AM - edited ‎03-15-2019 08:11 PM

Hello forum!

I am running CM 4.2(3) and after the firmware upgrade of the 7921 to 1-3-3 I have problems.

It registers normally but after some hour the message "NOT IN SERVICE" appears. Then it resets and the initial steps happen again:

1. Opening 172.16.x.x (cm ip)

2. Configuring IP

3. Confiruring CM List (somethimes it freezes)

4. Opening 172.16.x.x (again... and it freezes)

Any suggestions?

Firmware problem? Wireless problem?

Thanks in advance

Labels:
0 Helpful
1 Reply 1

asafayan
Level 4
Level 4

‎10-25-2009 02:54 PM

We run 4.13SR8a and have hundreds of 7921s and a handful of 7925s with no problems that you are describing.

0 Helpful
Customers Also Viewed These Support Documents