QOS on 6506E

Unanswered Question
Oct 22nd, 2009
User Badges:

I have a 6506E cat switch with IOS 122-18.SXF7. When I try to apply the service-policy to either a vlan or eth interface I get the message "priority command is not supported in output direction for this interface". Input does not work either. Has anybody seen this and is there a work around?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jon Marshall Thu, 10/22/2009 - 07:34
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

David


6500 switches do not support MQC commands in the same way that routers do. If you are trying to prioritize certain traffic then start with this example from the config docs -


http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SX/configuration/guide/qos.html#wp1750910


Jon

dvanhaaren Thu, 10/22/2009 - 08:14
User Badges:

Thanx Jon

I think we found a solution, but the docs will give me additional info to go forward with.


Thanx again

Actions

This Discussion