cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
552
Views
0
Helpful
2
Replies

QOS on 6506E

dvanhaaren
Level 1
Level 1

I have a 6506E cat switch with IOS 122-18.SXF7. When I try to apply the service-policy to either a vlan or eth interface I get the message "priority command is not supported in output direction for this interface". Input does not work either. Has anybody seen this and is there a work around?

2 Replies 2

Jon Marshall
Hall of Fame
Hall of Fame

David

6500 switches do not support MQC commands in the same way that routers do. If you are trying to prioritize certain traffic then start with this example from the config docs -

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SX/configuration/guide/qos.html#wp1750910

Jon

Thanx Jon

I think we found a solution, but the docs will give me additional info to go forward with.

Thanx again

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: