10-23-2009 12:14 PM - edited 03-04-2019 06:28 AM
I always have problems with this when configuring 3845s with a Switching module.
From what I understand, you just need to IP the interface gi2/0, and you're good to go, but I keep getting this:
mdf-rt-01#service-module gi2/0 session
Trying 10.52.240.1, 2130 ...
Here is relevant config:
interface GigabitEthernet0/0
description $ETH-LAN$$ETH-SW-LAUNCH$$INTF-INFO-GE 0/0$
no ip address
shutdown
duplex auto
speed auto
media-type rj45
interface GigabitEthernet2/0
description INTERNAL_ETHERNET_SWITCH_MODULE
ip address 10.52.240.1 255.255.240.0
ip verify unicast source reachable-via rx allow-default
ip helper-address 10.128.5.59
ip helper-address 10.128.5.50
no ip redirects
no ip unreachables
ip nbar protocol-discovery
ip pim sparse-mode
10-23-2009 12:25 PM
Which exact module is this? "show diag" if you are not sure.
10-23-2009 12:28 PM
My apologies:
Slot 2:
NME-XD-24ES-1S-P: EtherSwitch SM 24 10/100T PoE + 1 SFP + StackWise Port adapter, 1 port
Port adapter is analyzed
Port adapter insertion time 04:00:11 ago
EEPROM contents at hardware discovery:
Hardware Revision : 1.0
Top Assy. Part Number : 800-25012-02
Board Revision : A0
Deviation Number : 10-1987
Fab Version : 03
PCB Serial Number : FOCxxxxxxx
RMA Test History : 00
RMA Number : 0-0-0-0
RMA History : 00
Product (FRU) Number : NME-XD-24ES-1S-P
Version Identifier : V02
Base MAC Address : 0025.84db.f300
MAC Address block size : 128
EEPROM format version 4
10-25-2009 02:43 PM
Try removing all the config on Gig 2/0 (default interface Gig 2/0) and just put the IP address.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: