WiSM Virtualization

Unanswered Question
Oct 23rd, 2009
User Badges:

Hello


I ahve 2 Cisco Wism installed on 6506-E running virtualization. when I run show wism status, the controllers are unable to get IP addresses for the service and mangt interface knowing the Vlan is there and local dhcp configured. wism service command is also applied.

wism switch1 module 4 controller 1 allowed vlan is also applied all port are up including virutal port-channel and actual virtual ports that I am unable to configure

any suggestions?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Leo Laohoo Sun, 10/25/2009 - 17:15
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

Integrate Cisco Service Modules with Cisco Catalyst 6500 Virtual Switching System 1440

http://www.cisco.com/en/US/products/ps9336/products_tech_note09186a0080a7c72b.shtml#wism



Cisco WiSM in a Cisco Virtual Switching System Environment

http://www.cisco.com/en/US/products/hw/modules/ps2706/products_tech_note09186a0080a6c202.shtml

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode