Subinterfaces: point/multipoint

Unanswered Question
Oct 23rd, 2009

When I'm setting up subinterfaces in my frame-relay lab; does specifying the subinterface type (point-to-point | multipoint) do anything other than cause the OSPF default config, appropriate to that subinterface type, take effect?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Jerry Ye Fri, 10/23/2009 - 19:01

It will affect how your configure your DLCI.

Point-to-point uses the frame-relay interface-dlci xx command.

Multipoint uses the frame-relay map command (like configuring frame-relay on the physical interface).




This Discussion