ACE - active/standby

Unanswered Question
Oct 24th, 2009
User Badges:

Hi Experts,


I have Two ACE modules in bridge mode and its configured as active/standby.

But I cannot ping to the gateway from standby ACE. from the msfc side all the configurations are ok.


Could you plz help us to find the root cause of this ?

Rgds

Aslam


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
sachinga.hcl Mon, 10/26/2009 - 00:37
User Badges:
  • Silver, 250 points or more

Hi Aslam,


Can you please send me the config details of you admin Context by sending the output of the following commands:



# Show running-configuration


and


# show run ft


and # show ft group detail


I think there is some VLAN problem in your case either configured incorrectly or not included



Can you send your design


Like sample as follows:


FWSM--vlan 7--ACE-vlan 8---servers with default gateway as FWSM


Can you post the output for


show int vlan 505

sh arp



are you running ACE on a C6500 VSS pair?



Do you have an ip in your ACE vlan ?


If both of the device you are trying to ping are in the same VLAN as in ACE it does NOT route between VLANs so you cannot ping the interfaces in different VLANs.



Kindly send your config without which it will be difficult to figure out the exact root cause of your problem or any configuration mismatch.



Sachin Garg

aslamta123 Mon, 10/26/2009 - 01:35
User Badges:

Hi Sachin,


Thanks for the reply .. My issue has been resolved, It was due to the missing IP for the peer BVI interface..



Rgds

Aslam..

Actions

This Discussion