10-26-2009 02:38 AM - edited 03-06-2019 08:17 AM
Hi,
I have some 200 servers connected to my L3 switch. I am planning to SPAN for every server to one Sniffer. Is it technically viable? what are the possible challenges I might face ?
Thanks in advance..
10-26-2009 02:57 AM
Where is the SPAN destination located. Are you planning to do a local SPAN or a remote SPAN. SPAN is done in hardware so you can do it. You might just be hiiting the hardware limitation on the switch. With Local SPAN, you can create only 2 sessions and a maxiumum of 128 SPAN sources with Release 12.2(18)SXE and later.
Please read the doc below for all the restrictions before going ahead :
HTH,
-amit singh
10-26-2009 04:15 AM
Hi,
I am planning for Local SPan. If I do a Source SPAN with VLAN, inderectly covering all the ports, whether still I have hardware limitation......
10-26-2009 05:03 AM
Should not be a problem. But again it depends on the hardware how it behaves with such a huge traffic. As it is done in hardware, we beleive that you will be absolutely fine with it.
10-26-2009 05:52 AM
I will test my luck...
thanks for the data..
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide