10-26-2009 12:45 PM - edited 03-11-2019 09:31 AM
Hello folks,
this is my ASA 5520 failover output:
This host: Primary - Active
Active time: 1498 (sec)
slot 0: ASA5520 hw/sw rev (2.0/8.2(1)) status (Up Sys)
Interface outside (172.16.1.3): Normal (Waiting)
Interface inside (192.168.1.1): Normal (Waiting)
slot 1: empty
Other host: Secondary - Standby Ready
Active time: 0 (sec)
slot 0: ASA5520 hw/sw rev (1.1/8.2(1)) status (Up Sys)
Interface outside (0.0.0.0): Normal (Waiting)
Interface inside (0.0.0.0): Normal (Waiting)
slot 1: empty
My question is about the IP address shown in standby unit (0.0.0.0) for outside and inside interfaces. This is normal? The standby feature is working properly but this output makes me think about an issue on the failover configuration.
Can someone explain this?
Thanks!
Solved! Go to Solution.
10-26-2009 01:29 PM
Do you have standby ip addresses configured?
I.e.
interface
ip address 192.168.1.1 255.255.255.0 standby 192.168.1.2
10-26-2009 01:29 PM
Do you have standby ip addresses configured?
I.e.
interface
ip address 192.168.1.1 255.255.255.0 standby 192.168.1.2
10-27-2009 03:47 AM
Hi Herbert,
this is the point. I miss this command and after that, the output shown the correct address of standby unit.
Thank you!
Regards,
Rafael.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: