10-27-2009 01:18 AM - edited 03-15-2019 08:14 PM
Hello, im quite new to voip world, so i have a rewarding and challenging
Job, there is my question.
I manage a little network, we have a few PSTN lines to our GW, some of these lines are "fowarded" to IP extensions within the network using PLAR but i cant get the caller number to be displayed in the ip phone
Any suggestions?
Thanks in advance
Cesar
10-27-2009 01:37 AM
Hola Cesar,
First question is if you connect an analog phone do you recieve Caller ID from Telco?
Then enable caller id in voice ports by using caller-id enable command
http://www.cisco.com/en/US/docs/ios/12_3t/voice/command/reference/vrht_c4.html#wp1059594
Then you can post your config and run some debugs:
debug voice ccapi ino
debug vpm signal
10-27-2009 02:48 AM
Ok, I was supposing that i was receiving the information from telco but it was not right, thanks a lot for your help.
Cesar
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: