×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

ASA management

Unanswered Question
Oct 27th, 2009
User Badges:

When running two ASAs as Active/Standby; is there a way to have two different management addresses using two different networks?

(In a failure each ASA should keep its mgmt address. Basically exclude the mgmt interface from config synchronization.)


Thanks

Joe


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
francisco_1 Tue, 10/27/2009 - 05:41
User Badges:
  • Gold, 750 points or more

yes you can have both devices on different management address and exclude from failover monitor...But you can only make active configuration chaange on the active device though!

Jatin Katyal Tue, 10/27/2009 - 05:44
User Badges:
  • Cisco Employee,

Hi,


It should be from the same network.


HTH


JK

francisco_1 Tue, 10/27/2009 - 05:47
User Badges:
  • Gold, 750 points or more

yep. forgot to mentioned that. thanks JK.

jtorjman Wed, 10/28/2009 - 12:28
User Badges:

Would that require using the "standby" ip address on the mgmt interface with two different IPs but on the same subnet?


(I was hoping that the mgt interface config was not "synchronized.)


Thanks

Joe



Actions

This Discussion