10-27-2009 05:36 AM - edited 03-11-2019 09:31 AM
When running two ASAs as Active/Standby; is there a way to have two different management addresses using two different networks?
(In a failure each ASA should keep its mgmt address. Basically exclude the mgmt interface from config synchronization.)
Thanks
Joe
10-27-2009 05:41 AM
yes you can have both devices on different management address and exclude from failover monitor...But you can only make active configuration chaange on the active device though!
10-27-2009 05:44 AM
Hi,
It should be from the same network.
HTH
JK
10-27-2009 05:47 AM
yep. forgot to mentioned that. thanks JK.
10-28-2009 12:28 PM
Would that require using the "standby" ip address on the mgmt interface with two different IPs but on the same subnet?
(I was hoping that the mgt interface config was not "synchronized.)
Thanks
Joe
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: