cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
430
Views
0
Helpful
4
Replies

ASA management

joet8591
Level 1
Level 1

When running two ASAs as Active/Standby; is there a way to have two different management addresses using two different networks?

(In a failure each ASA should keep its mgmt address. Basically exclude the mgmt interface from config synchronization.)

Thanks

Joe

4 Replies 4

francisco_1
Level 7
Level 7

yes you can have both devices on different management address and exclude from failover monitor...But you can only make active configuration chaange on the active device though!

Jatin Katyal
Cisco Employee
Cisco Employee

Hi,

It should be from the same network.

HTH

JK

~Jatin

yep. forgot to mentioned that. thanks JK.

Would that require using the "standby" ip address on the mgmt interface with two different IPs but on the same subnet?

(I was hoping that the mgt interface config was not "synchronized.)

Thanks

Joe

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: