10-28-2009 12:49 AM - edited 03-04-2019 06:31 AM
I have an 1841 which has an ADSL WIC installed and also a VPN module.
Having trouble finding an IOS that supports both the ADSL WIC and VPN.
Currently got c1841-adventerprisek9-mz.124-25b.bin on there but this does not seem to support the ADSL WIC as i get these errors and the ATM interface does not show up;
CFG-3-CARD_NOT_SUPPORTED: Slot 0: Unknown WAN daughter card, Part# 73-9932-6, HW-Rev 8.0, Board-Rev A0
Router#sh ip int bri
Interface IP-Address OK? Method Status Protocol
FastEthernet0/0 unassigned YES NVRAM administratively down down
FastEthernet0/1 192.168.1.4 YES DHCP up up
however this image does support the VPN
Cisco 1841 (revision 7.0) with 234496K/27648K bytes of memory.
Processor board ID FHK12102A30
2 FastEthernet interfaces
1 Virtual Private Network (VPN) Module
DRAM configuration is 64 bits wide with parity disabled.
191K bytes of NVRAM.
62720K bytes of ATA CompactFlash (Read/Write)
The ip_base image supports the ADSL but not the VPN....
Anyone know of an IOS that supports both?
thanks
I have also tried c1841-entservicesk9 and c1841-advipservicesk9-mz
Both support the VPN but not the ADSL module... Any help would be greatly appreciated!
10-28-2009 01:03 AM
try Cisco Feature Navigator:
10-28-2009 01:06 AM
Hello Luca,
I would say 12.4T advanced enteprise take one of the late ones like 12.4(20)T
check with FN as explained in other post
Hope to help
Giuseppe
10-28-2009 03:53 PM
Can you provide the exact product ID of the card?
10-28-2009 04:17 PM
I dont have that at the moment but i found an IOS last night that worked.
11-06-2009 11:01 PM
Hi Luca
Can U tell me what ios you used?
I have the same problem tried several ios but none appreciate me
thanks
11-08-2009 02:00 PM
I used;
c1841-adventerprisek9-mz.124-24.T2
11-07-2009 02:20 AM
Hi,
The bellow image should support both:
c1841-advsecurityk9-mz.124-15.T7.bin
However, If you check the feature Navigator, you will find out that the (Advance Enterprise services) does supports both also. I am wondering why your hardware couldnt identify the ADSL WIC, keep in mind the WIC could be faulty.
HTH
Mohamed
11-07-2009 02:25 AM
thanks
ADSL iz working but router didn;t identify vpn module thats why ia have t find suitebale ios or I have to upgrade routers ram
thanks
11-07-2009 02:41 AM
Hi,
You dont have to upgrade the router ram.
You have a sufficient DRAM of 256 which is compatible with the required IOS. Try the IOS I have sent earlier.
HTH
Mohamed
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide