10-28-2009 02:57 AM - edited 03-06-2019 08:20 AM
Hi,
I have a doubt and I don't know if this possible.
Can I install a DSP (PVDM) from a 2600 series router into a 2600xm series router?
Regards
10-28-2009 08:08 AM
Hello Antonio,
you have a PVDM or PVDM2?
two different generations of DSPs exist for cisco routers so your question is wise.
Hope to help
Giuseppe
10-28-2009 08:12 AM
Thank you for your response Giussepe.
Sincerenly, I don't know exactly how can I discover what type of PVDM I have?
10-28-2009 08:55 AM
'sh voice dsp'
Check out DSP TYPE in the output.
10-28-2009 08:57 AM
I've already known it, but my problem is that the original router has crashed and I cannot execute this command.
If I connect this DSP, is there any risk?
10-28-2009 09:06 AM
I highly doubt you'll "fry" anything. If I were you I'd just try and see. Do you see any writing on the PVDM's at all?
10-28-2009 09:08 AM
When you tell "fry anything", what is anything?
PVDM?
Router?
10-28-2009 09:13 AM
Don't take my word for it but I doubt you'll ruin the router or the PVDM. Why don't you compare models on the DSP Calculator? http://www.cisco.com/cgi-bin/Support/DSP/cisco_configure.pl
You can plug in both of your router types and go from there.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
