jeromehenry_2 Wed, 10/28/2009 - 12:30
User Badges:
  • Silver, 250 points or more

It has to be a trunk, because the rogue detector is used to detect the ARP requests, so you need to connect it to a trunk so that all ARP requests from all VLANs are detected.

Hope it helps


Jerome


PS: please also check in this forum, there were a couple of threads about how to configure this AP and its trunk port.

George Stefanick Wed, 10/28/2009 - 21:37
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Best Publication, October 2015

Jerome... great response... I did not know that ... thanks for sharing ...



colmgrier Thu, 10/29/2009 - 03:04
User Badges:

What native VLAN will I use for the trunk port. The WLC is currently using VLAN 50 as native VLAN.

richard.leadbet... Tue, 11/03/2009 - 10:29
User Badges:

Hello,


I've also been trying this out with mixed results! I found that when the Rogue Detector's trunk had the native VLAN set to the same as the WLC's management interface it worked fine. However, when set to the local VLAN that the AP would normally reside in (seeing as I wanted to retain an L3 topology) it would not discover that a test rogue was on the LAN. Any ideas????


Thanks


Rich

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode