10-28-2009 09:24 AM - edited 03-15-2019 08:16 PM
I have a CME with voip dial-peers to a 2600 router. The 2600 has a frame-relay wan connectivity with vofr dial-peers to the far-end. Not sure if the 2600 will complete the call end-to-end going from voip h323 dial-peer to a vofr dial-peer. The far-end has a 2600 with pots dial-peer to a PBX.
Thanks,
10-28-2009 11:33 AM
No, it will not complete the call, because you cannot have call with one end VoFR and other VoIP.
Either convert to VoIP end-to-eend, or you will have to go thorough a POTS interface.
10-28-2009 11:42 AM
Thanks, for the info. So if I put an E-1 interface in the CME connected to the 2600 and use pots dial-peers from the CME to 2600 via the E-1 the call will complete at this point.
10-28-2009 03:17 PM
Yes it will, but it's expensive as it requires physical ports and DSPs. So VoIP end-to-end is often preferred.
Please remember to rate useful posts with the scrollbox below.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: