Re: Cisco Call Manager express 7.0

Unanswered Question
Oct 28th, 2009

I have installed and configured CME 7.0 and Unity Express and I was able to access and configure DN and Phones using the webinterface from Unity Express. However now when I access the Unity Express page and try to configure phone or extension I can't. The CME page launches but there is a X beside IP Telephony Service Engine and can't make these changes. Note dnedit and webedit are enabled. Can you assist with this?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion