cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2154
Views
0
Helpful
5
Replies

Switch Cisco and Microsoft NPS

joao
Level 1
Level 1

Hi,

I configure 802.1x wich Cisco Switch and Microsoft NPS Radius but the client cannot connect. I debug radius on switch and receive the debug attached.

Whats the problem??

Thanks

5 Replies 5

Jatin Katyal
Cisco Employee
Cisco Employee

Hi,

Looks like that switch ip address is 192.168.233.250

Please add this nas-ip-address 192.168.233.250 in the condition on the NPS server.

Also, could you please provide me a error message from the event viewer?

Attached is the document to configure NPS with cisco devices.

HTH

JK

Plz rate helpful posts-

~Jatin

Forgot to attach the file.

Here is the attachment

HTH

JK

Plz rate helpful posts-

~Jatin

I set everything equal to the document, but a receive the same error on Radius Debug

1w0d: RADIUS(00000048): Started 5 sec timeout

1w0d: RADIUS: Received from id 1645/51 192.168.233.16:1645, Access-Reject, len 44

1w0d: RADIUS: Response for non-existent request ident

Any idea???

Thanks

Hi,

I can clearly see that radius rejected the access-request that is why ia asked you to provide me the event viewer log message to get more detail.

Please get the event viewer log message for the access-reject.

HTH

JK

Plz rate helpful posts-

~Jatin

JK,

could you kindly repost pdf, it seems empty.

Thanks,

AS

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: