10-28-2009 02:14 PM - edited 03-15-2019 08:16 PM
Hi,
I just setup a new mgcp gateway which is fully register with the CCM and has all the channels in service but I can't make or receive calls.
I am trying to do some L3 debugging but after I enable the debug isdn q939 and term mon I am not getting output when I try to make a call.
I have already configured the logging to buffered 100000 7 but no success.
Does anyone know how to get this commando to work?
Thanks, RG
10-28-2009 03:20 PM
Check again show controller T1 and show ISDN status, the most likely cause is that L3 can't work at all.
10-28-2009 03:47 PM
I have check all that and it seems to be working. I get output when I do q921 but no with q931.
Any other suggestions? Thanks, RG
10-28-2009 04:59 PM
What output are getting ? Not all is conducive to working status.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: