10-28-2009 02:14 PM - edited 03-15-2019 08:16 PM
Hi,
I just setup a new mgcp gateway which is fully register with the CCM and has all the channels in service but I can't make or receive calls.
I am trying to do some L3 debugging but after I enable the debug isdn q939 and term mon I am not getting output when I try to make a call.
I have already configured the logging to buffered 100000 7 but no success.
Does anyone know how to get this commando to work?
Thanks, RG
10-28-2009 03:20 PM
Check again show controller T1 and show ISDN status, the most likely cause is that L3 can't work at all.
10-28-2009 03:47 PM
I have check all that and it seems to be working. I get output when I do q921 but no with q931.
Any other suggestions? Thanks, RG
10-28-2009 04:59 PM
What output are getting ? Not all is conducive to working status.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide