10-28-2009 03:30 PM
Hi,
I have a following configuration:
Router AUX port -> FW Console
If there is something problem in the FW I can log the FW from cisco aux but the problem is now that the aux port is sending character's to FW's console port and now if the FW is rebooting it will go bootloop because when the FW boot's there is situation where is something "press any key" and now cisco router sends characters and the FW boots again.
Router AUX port config is following:
line aux 0
no exec
transport input all
stopbits 1
Which aux-port config the Cisco won't send any character to FW's console.
br
J
10-29-2009 11:58 AM
Add "no logging console" to your configuration and see if that clears things up.
10-30-2009 01:58 AM
Hi Jody,
Thanks for your reply.
Actually I have no logging console configured at router but I will configure this also to the FW..I forgot to configure this at FW :)
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: