Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
331
Views
0
Helpful
1
Replies

2950 lost IOS ??

rico_hao40
Level 1
Level 1

‎10-29-2009 07:12 AM - edited ‎03-06-2019 08:22 AM

Hi

Something wrong with a 2950 when I boot it went to switch:

Then I tried this command

switch: flash_

Initializing Flash...

flashfs[0]: Checking block 4...bad block number (12)

flashfs[0]: erasing block 4...done.

flashfs[0]: Checking block 5...bad block number (13)

flashfs[0]: erasing block 5...done.

flashfs[0]: Checking block 6...bad block number (14)

Error message says" Bad block...", does that means the flash disk is broken? If not, how can i upload a IOS in this mode?

Thanks

Labels:
0 Helpful
1 Reply 1

d_ferraro
Level 1
Level 1

‎10-29-2009 08:31 AM

you could try to use xmodem via console to upload a new image(if there is room).

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card