Telnet to Ws-svc-cmm-6t1 Problems

Answered Question
Oct 29th, 2009

Would anybody know how I could get the configuration of our CMM. The modual is setup in our 6500 switch. This is what I have when I do sho CDP.

Device ID: OTTVGP01_CMM

Entry address(es):

IP address: 10.1.100.11

Platform: cisco WS-SVC-CMM Cat6k Voice Linecard, Capabilities: Router

Interface: GigabitEthernet4/1, Port ID (outgoing port): GigabitEthernet1/0

Holdtime : 130 sec

Version :

Cisco IOS Software, Cat6K-lc Software (wscmm-IPVOICE-M), Version 12.4(7b), RELEASE SOFTWARE (fc2)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2006 by Cisco Systems, Inc.

Compiled Thu 13-Jul-06 18:01 by ccai

advertisement version: 2

Duplex: full

----------------------------------------

When I try to telnet to the ip 10.1.100.11 I get the following error: Trying 10.1.100.11 ... Open

Password required, but none set

[Connection to 10.1.100.11 closed by foreign host]

My goal is to have th running config of this communication modul.

Thanks in advance, J

I have this problem too.
0 votes
Correct Answer by Jerry Ye about 7 years 2 months ago

What software is on you 6500?

If is it CatOS, you can do session mod_number.

If it is IOS, you can do session slot mod_number processor 0

http://www.cisco.com/en/US/docs/ios/12_3/12_3x/12_3xy/archive/gtcmm.html#wp1193907

HTH,

jerry

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.

Actions

This Discussion