10-29-2009 09:27 AM - last edited on 03-25-2019 04:08 PM by ciscomoderator
Would anybody know how I could get the configuration of our CMM. The modual is setup in our 6500 switch. This is what I have when I do sho CDP.
Device ID: OTTVGP01_CMM
Entry address(es):
IP address: 10.1.100.11
Platform: cisco WS-SVC-CMM Cat6k Voice Linecard, Capabilities: Router
Interface: GigabitEthernet4/1, Port ID (outgoing port): GigabitEthernet1/0
Holdtime : 130 sec
Version :
Cisco IOS Software, Cat6K-lc Software (wscmm-IPVOICE-M), Version 12.4(7b), RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2006 by Cisco Systems, Inc.
Compiled Thu 13-Jul-06 18:01 by ccai
advertisement version: 2
Duplex: full
----------------------------------------
When I try to telnet to the ip 10.1.100.11 I get the following error: Trying 10.1.100.11 ... Open
Password required, but none set
[Connection to 10.1.100.11 closed by foreign host]
My goal is to have th running config of this communication modul.
Thanks in advance, J
Solved! Go to Solution.
10-29-2009 09:31 AM
What software is on you 6500?
If is it CatOS, you can do session mod_number.
If it is IOS, you can do session slot mod_number processor 0
http://www.cisco.com/en/US/docs/ios/12_3/12_3x/12_3xy/archive/gtcmm.html#wp1193907
HTH,
jerry
10-29-2009 09:31 AM
What software is on you 6500?
If is it CatOS, you can do session mod_number.
If it is IOS, you can do session slot mod_number processor 0
http://www.cisco.com/en/US/docs/ios/12_3/12_3x/12_3xy/archive/gtcmm.html#wp1193907
HTH,
jerry
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide