ATM IMA help please

Unanswered Question

I have four T1 with ATM IMA configuration. The ATM interfaces are up/up state; However, when I bound the ima-group 0 statement to the ATM interfaces, the four atm interfaces will goes down. Do anyone have any idea about this? Am i missing anything on the config?

Thanks,

Peter

interface ATM1/0

no ip address

no atm oversubscribe

no atm ilmi-keepalive

ima-group 0

no scrambling-payload

!

interface ATM1/1

no ip address

no atm ilmi-keepalive

ima-group 0

no scrambling-payload

!

interface ATM1/2

no ip address

no atm ilmi-keepalive

ima-group 0

no scrambling-payload

!

interface ATM1/3

no ip address

no atm ilmi-keepalive

ima-group 0

no scrambling-payload

pvc 2/35

interface ATM1/IMA0

description IMA Group 0

no ip address

no atm ilmi-keepalive

ima clock-mode independent

!

interface ATM1/IMA0.1 point-to-point

bandwidth 6000

ip address 168.x.x.x 255.255.255.128

ip access-group 101 in

no ip unreachables

crypto map clientmap

pvc 2/35

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Giuseppe Larosa Sun, 11/01/2009 - 01:13

Hello,

your issue is similar to that of a recent thread.

first, look at the following

see the following documents:

http://www.cisco.com/en/US/tech/tk39/tk356/technologies_tech_note09186a0080093d52.shtml

ATM IMA ver. 1.1

http://www.cisco.com/en/US/tech/tk39/tk356/technologies_tech_note09186a008009455b.shtml

What device are you using and what IOS image is running?

Edit:

have you tried without the command

ima clock-mode independent

in IMA interface?

Hope to help

Giuseppe

Actions

This Discussion