I have Two T1 lines coming into our office. 1 is a full connected to it's own router (ISP's router). We also have another T1 that is split between voice and data (also terminates in another one of the same ISP's router). I have the default route set to the full T1. I need to configure a static route to send all traffic destined for a certain network out of the split T1. How would I configure this from the command line? I have a vlan for the full T1 (outside) and a vlan for the split T1. Is it possible to configure a static route to send all traffic destined for a particular network out of the vlan connected to the router with the split T1?