cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
665
Views
0
Helpful
4
Replies

CSS11506 performance report ?

albatli1977
Level 1
Level 1

Is there any tools for "Cisco CSS 11506 Content Services Switch CSS11506" to provide performance report?

1 Accepted Solution

Accepted Solutions

The enterprise level monitoring and management tool that Cisco makes for this class of device is Application Network Manager (ANM). See http://www.cisco.com/en/US/products/ps6904/tsd_products_support_series_home.html for information.

ANM is probably much more than you need. If you are using the Health and Utilization Monitor (HUM) component of CiscoWorks, your could set it to poll your CSS for MIB variables that are relevant to performance. Alternatively you could use a tool like CACTI or Nagios (open source management products) to do the same.

You can alternatively look at near real time monitoring on a CSS using the Web UI. See http://www.cisco.com/en/US/customer/products/hw/contnetw/ps792/products_tech_note09186a00801e05f5.shtml for setting up this functionality.

Finally, the CSS also has RMON capability. See the RMON and SNMP section of the CSS Administration Guides: http://www.cisco.com/en/US/customer/products/hw/contnetw/ps792/products_installation_and_configuration_guides_list.html

Hope this helps.

View solution in original post

4 Replies 4

albatli1977
Level 1
Level 1

Product Name: CSS11506-2AC E0 SW Version: 07.40.0.04

Product Name: CSS11503-AC E0 SW Version: 07.40.0.04

The enterprise level monitoring and management tool that Cisco makes for this class of device is Application Network Manager (ANM). See http://www.cisco.com/en/US/products/ps6904/tsd_products_support_series_home.html for information.

ANM is probably much more than you need. If you are using the Health and Utilization Monitor (HUM) component of CiscoWorks, your could set it to poll your CSS for MIB variables that are relevant to performance. Alternatively you could use a tool like CACTI or Nagios (open source management products) to do the same.

You can alternatively look at near real time monitoring on a CSS using the Web UI. See http://www.cisco.com/en/US/customer/products/hw/contnetw/ps792/products_tech_note09186a00801e05f5.shtml for setting up this functionality.

Finally, the CSS also has RMON capability. See the RMON and SNMP section of the CSS Administration Guides: http://www.cisco.com/en/US/customer/products/hw/contnetw/ps792/products_installation_and_configuration_guides_list.html

Hope this helps.

Thanks a lot.

I installed HUM1.2 over LMS3.2, and we have special request to monitor above nodes :

1-Throughput “In & out Bandwidth”

2-Layer 4 CPS “Connection/Sec”

3-Layer 7 CPS CPS “Connection/Sec”

4-Concurrent Connections “Connection/Sec”

Is it possible to monitor content switch with HUM or I should install other application and also could you please provide me MIS's related above items.

sorry, MIS's=MIB

Is it possible to monitor above variables of content switch with HUM or I should install other application and could you please provide me mib's related above variables.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco