!!!!! UCCX 7 script problem!!!!!!

Unanswered Question
Nov 1st, 2009
User Badges:


There is an problem faced me, that when I perform debugging for my script there is a message appeared to me " Task:25000000007 AcceptStep: Trigger is not contactApplication".

and when i apply this script to application i called it Test and try to hear what i do, but i hear "sorry we have a critical problem call us again".

the script is attached

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
atalante Mon, 11/02/2009 - 02:24
User Badges:


Did you add a CSQ and ressource groupe, whith agent ont UCCX appadmin. In your script the CSQ name is empty ! That's may explain the issue.



AhmedBassiony Mon, 11/02/2009 - 22:54
User Badges:

I still beginner in script editing, what is the values of the variables i must enter in CSQ

Jonathan Schulenberg Mon, 11/02/2009 - 05:50
User Badges:
  • Super Bronze, 10000 points or more
  • Cisco Designated VIP,

    2017 IP Telephony

You cannot play media or invoke steps that require an active contact (e.g. Accept) if you are doing an offline step-through debug within the CCX editor. For this you would need to perform a reactive debug instead.

Upload the script and assign it to an application.

Start a reactive debug on it.

Call a trigger for the application.

The script will appear in the editor and allow you to walk through it. The difference is that you now have a contact (yourself) in the script and can hear the output.


This Discussion