Secondary SUP CAT 6500

Unanswered Question
Nov 2nd, 2009

currently we have cat 6506 in our network with single SUP2

now we planned to put secondary SUP on the slot 2

once we inserted secondary SUP2 module with same IOS and model it went to STANDBY COLD state

we configured the primary SUP redunanacy mode as RPR+ and Same as Secondary

but why it says below details

why Operating Redundancy Mode = rpr

Redundant System Information :

------------------------------

Available system uptime = 15 weeks, 5 days, 16 hours, 3 minutes

Switchovers system experienced = 0

Standby failures = 1

Last switchover reason = none

Hardware Mode = Duplex

Configured Redundancy Mode = rpr-plus

Operating Redundancy Mode = rpr

Maintenance Mode = Disabled

Communications = Up

Current Processor Information :

-------------------------------

Active Location = slot 1

Current Software state = ACTIVE

Uptime in current state = 15 weeks, 5 days, 16 hours, 3 minutes

Image Version = Cisco Internetwork Operating System Software

IOS (tm) s222_rp Software (s222_rp-ADVIPSERVICESK9_WAN-M), Version 12.2(18)SXF10

a, RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2007 by cisco Systems, Inc.

Compiled Wed 19-Sep-07 12:15 by kellythw

BOOT = ,1;disk0:s222-advipservicesk9_wan-mz.122-18.SXF

10a.bin,1;

BOOTLDR = bootflash:c6msfc2-boot-mz.121-8a.EX

Configuration register = 0x2102

Peer Processor Information :

----------------------------

Standby Location = slot 2

Current Software state = STANDBY COLD

Uptime in current state = 12 hours, 46 minutes

Image Version = Cisco Internetwork Operating System Software

IOS (tm) s222_rp Software (s222_rp-ADVIPSERVICESK9_WAN-M), Version 12.2(18)SXF10

, RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2007 by cisco Systems, Inc.

Compiled Fri 13-Jul-07 02:59 by kellythw

BOOT = ,1;disk0:s222-advipservicesk9_wan-mz.122-18.SXF

10a.bin,1;

BOOTLDR = bootflash:c6msfc2-boot-mz.121-8a.EX

Configuration register = 0x2102

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Giuseppe Larosa Mon, 11/02/2009 - 11:13

Hello Vinoth,

my guess is that something has gone wrong in communication between the two supervisors you should try to reset the standby supervisor.

>> Standby failures = 1

you can also look at log buffer for redundancy messages.

the standby sup could be too slow in coming up and/or it was stopped by active sup.

Hope to help

Giuseppe

vinoth.kumar Wed, 11/04/2009 - 22:39

thanks for your reply

Yes,

we intially put the secodary SUP and we seen same issue it went ot STANDBY COLD so we removed and tested with the Standby CAT 6500 and found no issue with the IOS and booting image so again we inserted the SUP still the same

Regards,

Vinoth

Actions

This Discussion