LACP and Teaming

Unanswered Question
Nov 2nd, 2009
User Badges:

Hi everyone. I need to team together 4 ports of a gig switch (4507) and enable LACP. I think I can handle the etherchannel stuff but not so sure about the LACP. Any hints?

Bob

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Reza Sharifi Mon, 11/02/2009 - 10:24
User Badges:
  • Super Bronze, 10000 points or more
  • Cisco Designated VIP,

    2017 LAN

Bob,


For LACP, you have the option of active and passive and one side of the connection must be active.


LACP supports the automatic creation of EtherChannels by exchanging LACP packets between LAN

ports. LACP packets are exchanged only between ports in passive and active modes.

The protocol learns the capabilities of LAN port groups dynamically and informs the other LAN ports.

Once LACP identifies correctly matched Ethernet links, it facilitates grouping the links into an

EtherChannel. The EtherChannel is then added to the spanning tree as a single bridge port.

Both the passive and active modes allow LACP to negotiate between LAN ports to determine if they can

form an EtherChannel, based on criteria such as port speed and trunking state. Layer 2 EtherChannels

also use VLAN numbers.

LAN ports can form an EtherChannel when they are in different LACP modes as long as the modes are

compatible. For example:

• A LAN port in active mode can form an EtherChannel successfully with another LAN port that is

in active mode.

• A LAN port in active mode can form an EtherChannel with another LAN port in passive mode.

• A LAN port in passive mode cannot form an EtherChannel with another LAN port that is also in

passive mode, because neither port will initiate negotiation.


HTH

Reza

Actions

This Discussion