CME question

khayes1984 · ‎11-03-2009

I currently have 128MB of RAM and 32MB of flash. I was wondering if I could run 4.1 on my router? Also I have 2 7960 phones, and a 7940 phone as well. Do I have enough to run CME 4.1? also which 12.4T version of IP Voice would fit on my router.

Sushil Kumar Katre · ‎11-03-2009

Hi Kenneth,

You didn't specified the Router model you are having.

Refer to this link to check which IOS version you need to have with respect to a specific CME release - http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/requirements/guide/33matrix.htm

For CME 4.1 you need to have 12.4(15)T7 IOS version.

Following link under section "Supported Platforms and Memory Specifications" states the memory recommendation for specific router models -

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/requirements/guide/cme41spc.htm

Hope this helps.

-> Sushil

khayes1984 · ‎11-04-2009

2621XM sorry.

Rob Huffman · ‎11-04-2009

Hi Kenneth,

Just to add a note to the great tips from my friend Sushil (+5 points for your good help buddy :)

Supported Platforms and Memory Specifications: SCCP IP Phones

Cisco 261xXM, 262xXM

Maximum Total IP Phones = 36

Maximum Total SCCP Phones = 36

Maximum Total Ephone-dns or Virtual Ports = 144

Recommended DRAM = 128

Recommended Flash Memory = 48

Cisco Unified CME 4.1 Supported Firmware, Platforms, Memory, and Voice Products

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/requirements/guide/cme41spc.htm

Hope this helps!

Rob

khayes1984 · ‎11-04-2009

dude you guys rock!

Rob Huffman · ‎11-04-2009

Hi Kenneth,

Glad to be of some small help here :)

Cheers!

Rob

khayes1984 · ‎11-04-2009

One more question. Since I only have 128 MB of Ram and 32 MB of flash can I atleast get call manager express on the router and get the phones working then upgrade the flash?