Task inactive Exception

Unanswered Question
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Anthony Holloway Wed, 11/04/2009 - 06:58
User Badges:
  • Purple, 4500 points or more

Are you using the On Exception Goto Step to catch Inactive Contacts and ending the script cleanly, instead of letting it fail?

Also, are you using a 2 second delay before the Accept step to allow CUCM and UCCX to complete the call setup?

christfoster Mon, 11/16/2009 - 17:35
User Badges:

Where should the the exception task goto step be place? We are experiencing these errors withing all our queues...

Jonathan Schulenberg Mon, 11/16/2009 - 17:55
User Badges:
  • Super Bronze, 10000 points or more
  • Cisco Designated VIP,

    2017 IP Telephony


On Exception Goto (ContactInactiveException) Goto END

Accept of script...

Disconnect [Label: DISCONNECT_END]

End [Label: END]

Note that callers will (and should) show as abandoned if this exception is caught. You might want to review my answer to another post if you want to control this at a more granular level:

christfoster Mon, 11/16/2009 - 19:26
User Badges:

What does this error mean ?

After restarting my UCCX we have been receiving over 200 abandon calls with this error..

jawilson_1 Fri, 08/16/2013 - 12:56
User Badges:

Jonathan, I can't find your post anywhere.  Do you still have it after all this time?

Mustapha Arakji Sun, 10/16/2011 - 15:19
User Badges:

Hi Guys,

Still looking for an answer regarding this message. I'm checking my UCCX reports and i can see a significant number of Aborted calls with reason code: I can't understand why, though i have debuged the script and couldn't find an error in the script.

Also I'm using the Exception Goto setp and ending the script successfully. In my report i can see the call is sent to a CSQ, then get aborted !! If the caller hangs up shouldn't the report show as abandoned !?



This Discussion