WLC - Manual AP Failback

Answered Question
Nov 4th, 2009

Hi,

I have disabled automatic failback as I would like to failback in a controlled manner should the primary WLC fail. However, is there a "nice" way to do this without either rebooting the AP's or rebooting the secondary WLC?

Thanks

I have this problem too.
0 votes
Correct Answer by dancampb about 7 years 3 weeks ago

You could reboot either device like you mentioned or you could just re-enabled AP fallback temporarily.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
dancampb Wed, 11/04/2009 - 12:37

You could reboot either device like you mentioned or you could just re-enabled AP fallback temporarily.

serotonin888 Wed, 11/04/2009 - 13:34

Thanks - Good point about re-enabling the AP fallback for a short period. Much nicer than rebooting things.

Thanks for your help

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode