cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
640
Views
0
Helpful
2
Replies

WLC - Manual AP Failback

serotonin888
Level 1
Level 1

Hi,

I have disabled automatic failback as I would like to failback in a controlled manner should the primary WLC fail. However, is there a "nice" way to do this without either rebooting the AP's or rebooting the secondary WLC?

Thanks

1 Accepted Solution

Accepted Solutions

dancampb
Level 7
Level 7

You could reboot either device like you mentioned or you could just re-enabled AP fallback temporarily.

View solution in original post

2 Replies 2

dancampb
Level 7
Level 7

You could reboot either device like you mentioned or you could just re-enabled AP fallback temporarily.

Thanks - Good point about re-enabling the AP fallback for a short period. Much nicer than rebooting things.

Thanks for your help

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: