Show int status vs show controller lre status link

Unanswered Question
Nov 4th, 2009

WS-C2924-LRE-XL

flash:c2900xl-c3h2l9s-mz.120-5.WC8.bin

What is the difference between the status from "show int status", in comparison with "show controller lre status link"?

I currently see the following:

*Show int status

Lo0/22 connected 1 Half A-10 100BaseTX/FX

*Show controller lre status link

Lo0/22 DOWN 0 2772 0.0 0.0 0 0 0x04

Any ideas?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Giuseppe Larosa Thu, 11/05/2009 - 06:02

Hello Jason,

the second show should be more detailed and specific of LRE DSL technology:

I have a device of same model in my case the two match on status:

sh int lo0/2 status

Port Name Status Vlan Duplex Speed Type

Lo0/2 prova secondo LRE connected trunk full 100 LRE

sh controller lre status link lo0/2

Port Link SNR RS Errs CPE-Tx Sw-AGC-Gain Interleaver PMD-S

(dB) (dBm/Hz) (dB) Rx-Bsz Tx-Bsz

------ ---- ---- ----------- -------- ----------- ------------- -----

Lo0/2 UP 36 0 - 65.4 12.6 16 16 0x04

so in my case I see coherent information

Hope to help

Giuseppe

Actions

This Discussion