Buy or Renew
Buy or Renew
Duo Security forums now LIVE! Get answers to all your Duo Security questions. Learn more
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
4614
Views
0
Helpful
4
Replies

promiscuous mode and inline pair

alsayed
Level 1
Level 1

‎11-04-2009 12:32 PM - edited ‎03-10-2019 04:49 AM

Hello

1) What's the difference between promiscuous mode and inline pair pair?

2) Where the necessary use of each mode?

3) if I have I-BANKING server located in the DMZ network, so what mode should be prefer

4)after the preferred mode then do I need to assign sensor on the outside and DMZ and the C&C in inside

Pls guide me

Labels:
0 Helpful
4 Replies 4

andrey.dugin
Level 1
Level 1

‎11-05-2009 04:49 AM

In promiscuous mode your sensor doesn't affect the traffic but it only listen and analyze it.

In inline mode you direct all your traffic on this network segment you want to protect to IPS and it analyze it and block some actions according to your settings.

It is the main difference. Which mode to prefer must be your decision.

0 Helpful

Adam Frederick
Level 3
Level 3
In response to andrey.dugin

‎11-05-2009 12:33 PM

with inline mode, do you actually plug the connection from the Internet in what would normally be your promiscous interface? I'm a little confused on how traffic is routed to the IPS first and then on to the firewall.

0 Helpful

alsayed
Level 1
Level 1
In response to Adam Frederick

‎11-06-2009 04:31 AM

hello

can u post me a usefull design guide with the IPS

10xs

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card