11-04-2009 01:18 PM - edited 03-13-2019 06:44 PM
Any idea why I cannot ping the AIM-CUE ?
thanks
interface Service-Engine0/0
ip address 10.224.32.17 255.255.255.252
service-module ip address 10.224.32.18 255.255.255.252
service-module ip default-gateway 10.224.32.17
!
#ping 10.224.32.18
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.224.32.18, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)
11-04-2009 01:33 PM
Check that module is running, via service-module session.
11-04-2009 10:46 PM
I can make session to module, and also it says up when I check it.
11-05-2009 02:06 AM
When is session, check with the show commands, thta the addresses are right.
11-05-2009 02:33 AM
Hi,
Check to have an ip route to the service module ip address with subnet /32 and output interface service engine
thanks & best Regards
Hytham Hadad
11-05-2009 02:37 AM
That should not be necessary, because a dedicated subnet is being used, not unnumbered.
However, I agree that unnumbered using a voice VLAN address is a better choice.
11-05-2009 03:19 AM
I reloaded the module and it is ok now :) interesting...
11-05-2009 03:35 AM
Why you should ?
Either use explicit or unnmbered, as recommended by configuration guides.
11-07-2009 10:29 AM
Hi Paolo
thanks for our note
11-07-2009 10:49 AM
You are welcome, please remember to rate useful posts with the scrollbox below.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: