Standby Supervisor (unknown)

Unanswered Question
Nov 4th, 2009
User Badges:

I have 4510 , I installed supervisor engine witch is a standby , I get a unknow mode , can some one pls help


Thanks



Mod Ports Card Type Model Serial No.

---+-----+--------------------------------------+------------------+-----------

1 2 1000BaseX (GBIC) Supervisor(active) WS-X4516 JAE0934JGL9

2 Standby Supervisor



M MAC addresses Hw Fw Sw Status

--+--------------------------------+---+------------+----------------+---------

1 0022.8041.c800 to 0022.8041.c801 2.2 12.2(31r)SG2 12.2(18)EW3 Ok

2 Unknown Unknown Unknown Other

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
yjdabear Wed, 11/04/2009 - 15:22
User Badges:
  • Gold, 750 points or more

I have a similar issue, except it's concerning a cat6k:


http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=Network%20Management&topicID=.ee71a02&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.2cd4d978


What kind of "help" are you looking for?


What's the "show redund" output on the 4510?


At the risk of stating the obvious, I think such issue almost always boils down to the standby Sup is going to be RMA'ed.

Actions

This Discussion