CUCM 6.1.4 Replication state 4 and 3

Unanswered Question
Nov 5th, 2009
User Badges:

Hello all,

I am having replication state 4 with one subscriber and 3 with al the others. I have tried utils dbreplication reset and repair, each time after utils dbreplication stop in all subs and then in pub. Any idea in how to recover?

One sympton, is that the same list of servers does not appears in the result of show tech dbstateinfo in all the servers.

Thanks for your help

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
virverma Thu, 11/05/2009 - 18:29
User Badges:
  • Silver, 250 points or more

Get root access for all the servers. Update the hosts with right entries. reset cluster.



make sure you understood this....


utils dbreplication clusterreset


This command resets database replication on an entire cluster.


Command Syntax


utils dbreplication clusterreset


Usage Guidelines


Before you run this command, run the command utils dbreplication stop first on all subscribers servers, and then on the publisher server.


Requirements


Command privilege level: 0


Allowed during upgrade: Yes

utils dbreplication dropadmindb


This command drops the Informix syscdr database on any server in the cluster.


Command Syntax


utils dbreplication dropadmindb


Usage Guidelines


You should run this command only if database replication reset or cluster reset fails and replication cannot be restarted.


Requirements


Command privilege level: 0


Allowed during upgrade: Yes

mcecilia Fri, 11/06/2009 - 12:14
User Badges:

Thanks for the answer. Suppose I do not understand the root access solution ;-) . Could it be posible to delete from Cluster and poweroff the Subscriber with 4 status, and then, reinstall it as if a new adition of subscriber where done? Then, it will be updated in all the Subs and Pub and the info about others will be downloaded to it during installation. What do you think about this?

virverma Sat, 11/07/2009 - 04:10
User Badges:
  • Silver, 250 points or more

You can do this but dont u think its a long procedure for you?

mcecilia Tue, 11/10/2009 - 08:50
User Badges:

Finally, there was a problem with connectivity between 2 of the 3 subscribers. Once solved, it started working after rebooting publisher.

In cli, the command "utils diagnose module validate_network" is very usefull to look for this types of errors.

Thanks for your help.

Actions

This Discussion