11-07-2009 07:31 PM - edited 03-13-2019 06:45 PM
I'm trying to install a 7941G phone on a 2811 router running IOS 12.4(3d), CME 3.3 and CUE 2.1.3. The phone is not adding in CME and the phone loads I downloaded are not registering on the router. I've been trying to find documentation on installing the phone and I found one good one but can't find it again. Can anyone let me know if I have the correct IOS and CME/CUE software versions and if there is a good install document out there.
11-08-2009 06:28 AM
Hi Danny,
The 7941G is not supported with CME 3.3
Cisco CallManager Express 3.3 Supported Firmware, Platforms, Memory, and Voice Products
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/requirements/guide/cme33spc.html
You would want to go to at least CME 4.1
Cisco Unified CME 4.1 Supported Firmware, Platforms, Memory, and Voice Products
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/requirements/guide/cme41spc.htm
Here is an excellent guide
Hope this helps!
Rob
11-08-2009 07:23 AM
Thanks for your reply and all your help. Do you know if 4.1 has to be purchased or can I upgrade from 3.3? What components do I need to upgrade? What particular files need to be downloaded?
11-08-2009 07:33 AM
Hi Danny,
You are most welcome my friend :)
CME is part of the IOS, so if you have a service contract that allows you access to the IOS downloads you are good to go;
The required steps are nicely listed in this doc;
Installing and Upgrading Cisco Unified CME Software
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmeinstl.html
This thread has a nice note from Paolo!
http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified Communications and Video&topic=IP Telephony&CommCmd=MB?cmd=pass_through&location=outline@^1@@.1dde8b54/2#selected_message
Hope this helps!
Rob
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: