Port Load Balancing

Unanswered Question
Nov 8th, 2009
User Badges:

Hey folks,


Need some help with the following:


I have a class map that load balances by IP address any port/protocol...I want to NOT load balance a specific port...I think the following will do the trick, but am not positive...if anybody has any input, please provide.


class-map match-all HQ_OCS_Front_End_to_Edge_Internal_WebConf_Policy_VIP_L4

description FE to Edge Web Conf

2 match vitual-adress <IP> any


no match port tcp eq 8057



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Gilles Dufour Mon, 11/09/2009 - 02:59
User Badges:
  • Cisco Employee,

unfortunately that would not work.

The 'no ...' command is only used to remove a previously configured command.


What you can do is create an access-list to block traffic sent to port 8057 and use this access-list as an access-group in on your inbound vlan interface.


Gilles.

Actions

This Discussion