11-09-2009 07:55 AM - edited 03-15-2019 08:24 PM
hello folks
do you know or could you share a document that will explain cme to cme integration ?
thank you
Solved! Go to Solution.
11-09-2009 08:10 AM
Basically, you would just have dial-peers on each cme pointing to the remote site:
example:
California router
dial-peer voice 100 voip
description **Calls to Indianapolis**
destination-pattern ....(extensions in Indy)
session target ipv4:x.x.x.x (IP of Indy router)
dtmf-relay h245-alphanumeric
Indy router
dial-peer voice 100 voip
description **Calls to California**
destination-pattern ....(extensions in Cali)
session target ipv4:x.x.x.x (IP of Cali router)
dtmf-relay h245-alphanumeric
Hope that helped, if so please rate.
11-09-2009 08:04 AM
Hello,
Can you be more specific? Are you just trying to network CME's at 2 different sites? Please explain further.
11-09-2009 08:06 AM
yes
I'd like to integrate 2 CME systems in 2 different locations
Indianapolis, California
there's going to be a VPN tunnel between the 2 sites and I'd like to have 4 digit dialing between the 2 sites
the site in indianapolis currently has cme version 4.2, the site in california has cme version 4.1
and i think i may need a GK for BW control, but i'm not sure i haven't found something that will explain how to integrate the 2 systems together
11-09-2009 08:10 AM
Basically, you would just have dial-peers on each cme pointing to the remote site:
example:
California router
dial-peer voice 100 voip
description **Calls to Indianapolis**
destination-pattern ....(extensions in Indy)
session target ipv4:x.x.x.x (IP of Indy router)
dtmf-relay h245-alphanumeric
Indy router
dial-peer voice 100 voip
description **Calls to California**
destination-pattern ....(extensions in Cali)
session target ipv4:x.x.x.x (IP of Cali router)
dtmf-relay h245-alphanumeric
Hope that helped, if so please rate.
11-10-2009 10:27 AM
hello,
I configured the dial-peers however i can only call the phones from california to indy. if i try to call from indy to california i get fast busy ... what am i doing wrong ?
11-10-2009 10:44 AM
problem resolved
thanks
11-11-2009 09:37 PM
how did you resolve it
11-12-2009 07:13 AM
I did a debug voice ccapi inout and realize that when i was placing the call it was actually getting to the remote ccme however the incoming dial-peer was wrong i reconfigure it and it fix my issue
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: