11-09-2009 07:55 AM - edited 03-15-2019 08:24 PM
hello folks
do you know or could you share a document that will explain cme to cme integration ?
thank you
Solved! Go to Solution.
11-09-2009 08:10 AM
Basically, you would just have dial-peers on each cme pointing to the remote site:
example:
California router
dial-peer voice 100 voip
description **Calls to Indianapolis**
destination-pattern ....(extensions in Indy)
session target ipv4:x.x.x.x (IP of Indy router)
dtmf-relay h245-alphanumeric
Indy router
dial-peer voice 100 voip
description **Calls to California**
destination-pattern ....(extensions in Cali)
session target ipv4:x.x.x.x (IP of Cali router)
dtmf-relay h245-alphanumeric
Hope that helped, if so please rate.
11-09-2009 08:04 AM
Hello,
Can you be more specific? Are you just trying to network CME's at 2 different sites? Please explain further.
11-09-2009 08:06 AM
yes
I'd like to integrate 2 CME systems in 2 different locations
Indianapolis, California
there's going to be a VPN tunnel between the 2 sites and I'd like to have 4 digit dialing between the 2 sites
the site in indianapolis currently has cme version 4.2, the site in california has cme version 4.1
and i think i may need a GK for BW control, but i'm not sure i haven't found something that will explain how to integrate the 2 systems together
11-09-2009 08:10 AM
Basically, you would just have dial-peers on each cme pointing to the remote site:
example:
California router
dial-peer voice 100 voip
description **Calls to Indianapolis**
destination-pattern ....(extensions in Indy)
session target ipv4:x.x.x.x (IP of Indy router)
dtmf-relay h245-alphanumeric
Indy router
dial-peer voice 100 voip
description **Calls to California**
destination-pattern ....(extensions in Cali)
session target ipv4:x.x.x.x (IP of Cali router)
dtmf-relay h245-alphanumeric
Hope that helped, if so please rate.
11-10-2009 10:27 AM
hello,
I configured the dial-peers however i can only call the phones from california to indy. if i try to call from indy to california i get fast busy ... what am i doing wrong ?
11-10-2009 10:44 AM
problem resolved
thanks
11-11-2009 09:37 PM
how did you resolve it
11-12-2009 07:13 AM
I did a debug voice ccapi inout and realize that when i was placing the call it was actually getting to the remote ccme however the incoming dial-peer was wrong i reconfigure it and it fix my issue
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide