Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
900
Views
0
Helpful
3
Replies

How to load an image on a LAP1252 with the bootloader

cjw
Level 1
Level 1

‎11-09-2009 12:22 PM - edited ‎07-03-2021 06:14 PM

Hello--

I have a LAP1252 that lost the flash image, consequently, when it tries to boot, the boot loader can not find anything to load. I can not find any documentation on how to use the TFTP client on the AP, can anyone point me in the right direction?

Thank you.

Labels:
0 Helpful
3 Replies 3

Leo Laohoo
Hall of Fame
Hall of Fame

‎11-09-2009 01:48 PM

Converting a Lightweight Access Point Back to Autonomous Mode

http://www.cisco.com/en/US/docs/wireless/access_point/conversion/lwapp/upgrade/guide/lwapnote.html#wp161272

0 Helpful

cjw
Level 1
Level 1
In response to Leo Laohoo

‎11-09-2009 01:57 PM

Actually, I do not want to convert it. I want to find the light weight image and restore it so that it can talk to the controllers again.

believe I know how to make it perform the TFTP, I just can not find the light weight images, only the autonomous images.

0 Helpful

Leo Laohoo
Hall of Fame
Hall of Fame
In response to Leo Laohoo

‎11-09-2009 03:30 PM

The link provided will allow you to copy an IOS using the "mode button" method.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card